What is the replica Planet Ocean Ultra Deep orange?
The replica Planet Ocean Ultra Deep orange is a copy of Omega's 6,000 m Seamaster dive watch, built with the orange accents that mark the seconds hand, dial text and bezel scale. It mirrors the genuine 45.5 mm case and ceramic bezel, but it does not carry METAS Master Chronometer certification or a real 6,000 m depth rating.
Genuine specs a good replica has to match
Omega launched the commercial Ultra Deep in 2022, three years after a prototype survived a 10,928 m dive in the Mariana Trench. The numbers below are the benchmark every copy is measured against.
- Case: 45.5 mm diameter, about 15.1 mm thick, grade 5 titanium Manta lugs and a titanium diving bell caseback on the steel model
- Water resistance: 6,000 m / 20,000 ft, tested to a higher equivalent pressure than the rating
- Movement: Co-Axial Master Chronometer Calibre 8912, 60 hour power reserve, 15,000 gauss magnetic resistance
- Crystal and bezel: thick domed sapphire with anti-reflective coating, ceramic unidirectional dive bezel with a lume pip at 12
- Accents: orange on the seconds hand, dive scale and dial printing
Does the orange version differ from the black dial Ultra Deep?
No. Orange is an accent, not a separate model line, so the case, bezel, movement and depth rating stay the same across the range. Reference numbers and strap options change, and sellers use "orange" as shorthand so buyers can find the accent variant quickly.
What should you check before buying one?
Case size and thickness
Measure before you commit. A correct Ultra Deep is 45.5 mm across and roughly 15 mm thick, while budget copies often shrink to 43 mm or thin out to 13 mm. Those few millimeters change how the watch sits on a 7 inch wrist.
Orange tone consistency
On the genuine watch the orange on the hand, bezel and dial text reads as one color. Cheap copies mix two or three different oranges, and the printed text looks flat or fuzzy under a loupe.
Bezel action and lume
A proper bezel turns in 120 crisp clicks, stops without back play, and lines up dead center at 12. Lume should be bright and even across the markers and the pip, not patchy.
Movement and finishing
Mid-tier copies run a Miyota 9015 or a generic automatic, while top-tier factories build a decorative clone of the 8912 architecture. Check the rotor engraving, the balance wheel beat rate and the sweep of the seconds hand.
Water resistance
Treat any replica as splash resistant at best. Gaskets, crown threads and caseback torque are not built or tested to the standard of the original, so no copy earns an honest 300 m rating, let alone 6,000 m.
What does a good replica cost?
Top-tier super clones of the Ultra Deep usually land between $350 and $600, and low-grade copies sell for under $150. Titanium finishing, a cloned movement and a correctly set bezel insert drive most of the price difference.
FAQ
Is a replica Ultra Deep safe to swim with?
Light swimming in a pool is usually fine if the caseback and crown are properly sealed. Diving, high-pressure washing and salt water are not worth the risk on any replica.
How do I spot a cheap copy fast?
Look at the date alignment, the crystal height and the lume. A misaligned date wheel, a flat crystal and dim lume are the three fastest tells.
Will the replica keep accurate time?
A regulated clone or a Miyota 9015 typically holds within 10 to 20 seconds a day. That is well outside Master Chronometer tolerance of 0 to +5 seconds.
Bottom line
The best replica Planet Ocean Ultra Deep orange gets the case proportions, the ceramic bezel and the orange accents close enough to pass on the wrist. Judge it on thickness, bezel feel, lume and movement, and never trust the depth rating printed on the dial.